New Zealand ADSL Mailing List


Re: Nokia M10 software releases

From: kit <a.bob_at_xtra.co.nz>
Date: Sun, 08 Aug 1999 18:22:27 -0400
Message-ID: <37AEF233.7037F3A5@xtra.co.nz>

Thank you Dan (and friend)

The idea behind doing a survey was in part to
1. Find out what the latest Software was and
2 . Find out how many older versions were around.

Is this to mean that 5.2.3 is a later version or was that a typo for
5.1.3
I suspect that the majority of modems are 5.1.3 but that there are
others
still out there. (i did make a point of noting the dates on the Nokia
page
and that they were quite possibly not the software that was required)

It would be nice if there was a source of genuine information that meant
we did not have to go to the extent of asking odd questions on the list.
And guessing at the actual answers.
(This is a comment for policy consideration)

--kit

Dan Langille wrote:
>
> The following was sent to me by a list member within Telecom.
>
> The original M10's were supplied with V2.0 software. The Vendor identified
> some internal problems with this release and upgraded Telecom's modems to V2.2
> Build 5.0.1R0.
>
> After a software upgrade to another device in the network issues were identified
> with the 501R0 software. This exhibited faults of link dropping and internal
> lockup under some authentication conditions. The cause for this could not be
> clearly identified. As part of the diagnosis an emergency
> patch, release 5.1.0R0, was loaded into several modems known to be most affected.
>
> In parallel with this the Vendor produced a fully regression tested version
> of the software and this is release V2.2 5.1.3R2. Please note 510.R0 did not
> address all the problems
> and was an emergency release to assist in identifying the cause of problems.
>
> The ONLY version of software that is compatible with the Telecom network is
> V2.2 5.2.3R0. Any earlier version will have problems. The most common symptoms
> are loss of connection
> with automatic re-authentication or loss of connection and internal lockup.
> The only clearance for this is to power down for up to 5 mins and then try again.
> --
> Dan Langille
>
> To unsubscribe: send mail to majordomo@freebsddiary.cx
> with "unsubscribe adsl" in the body of the message

To unsubscribe: send mail to majordomo@freebsddiary.cx
with "unsubscribe adsl" in the body of the message
Received on Sun Aug 8 18:22:27 1999


This archive was generated by hypermail 2.2.0 : Thu Nov 30 11:48:35 2006 EST