Well, I've just converted my pinholes over. And
basically, it's all open straight into my firewall.
 Thanks.

For those that aren't sure what to do, here's what
I did:

browse to 192.168.1.254
click on Pinhole
delete all entries

add the following two entries (I've swapped rows
for columns because the columns won't fit across
the page). Note: 192.168.1.1 is assumed to be the
IP address of your machine.

External StartPort 1 1
External Port End 65535 65535
Protocol UDP TCP
Internal IP Address 192.168.1.1 192.168.1.1
Internal Port 1 1

click on home
click on Restart M10
click on Restart

wait for the modem to restart

This will remove all filtering from the modem and
therefore open all ports. Good luck.

--
Dan Langille - DVL Software Limited
The FreeBSD Diary     - http://www.FreeBSDDiary.org/freebsd/
NZ FreeBSD User Group - http://www.nzfug.nz.freebsd.org/
The Racing System     - http://www.racingsystem.com/racingsystem.htm
To unsubscribe: send mail to majordomo@freebsddiary.cx
with "unsubscribe adsl" in the body of the message