Michael,
vcc2 is used to change the software. This vcc is mapped to Telecom for the duration of the upgrade but it is not possible to access the ethernet side (your network).

Cheers
Wayne

>>> "Michael Bordignon" <michael.b@infometrics.co.nz> 8/05/00 13:57:46 >>>
Even if the telnet port isn't pinholed (which it is on ours :) you can't
telnet to the M10 on the vcc1 interface can you? I thought it was only the
LAN interface you could telnet to it on...

Cheers

-----Original Message-----
From: Mark Barlow [mailto:Mark.Barlow@telecom.co.nz]
Sent: Monday, 8 May 2000 1:31 PM
Subject: Re: Firmware upgrade??????

Hi Andrew,

We haven't tried to upgrade your modem yet! The upgrade process will take a
week or so though so please be patient.
Once we have finished upgrading all the modems we can remotely, we will
generate a report of who wasn't upgraded and try to determine why. Usual
issues are - Telnet (port 23) pinholed, admin password changed by user or
modem switched off.
We will then contact people and resolve the issue in an appropriate fashion.

Thanks,
Mark Barlow :-)
ADSL Manager
e: mark.barlow@telecom.co.nz

>>> "Andrew Hooper" <telomere@iconz.co.nz> 05/05/00 09:33 >>>
Hi All,

I deleted the message he sent (perhaps someone could repost), but I was sure
the ADSL manager said firmwares would be updated between midnite and 6am
today - well, I'm still on 5.1.0 here....

Andrew

To unsubscribe: send mail to majordomo@freebsddiary.cx
with "unsubscribe adsl" in the body of the message

To unsubscribe: send mail to majordomo@freebsddiary.cx
with "unsubscribe adsl" in the body of the message

To unsubscribe: send mail to majordomo@freebsddiary.cx
with "unsubscribe adsl" in the body of the message

To unsubscribe: send mail to majordomo@freebsddiary.cx
with "unsubscribe adsl" in the body of the message
Received on Mon May 8 16:15:01 2000