Well so far I convert pinholes to the new syntax (but not if I find pinholes on
the new modem), set the ethernet ip address and netmask if the M(W)1122 has the
standard address and the backup config is different, check if DHCP was turned
off, check if pap authentication is set (common mistake) and set the username
and password if they haven't been done. I'm currently adding a section to check
if the DHCP start and end ranges are set to something other than standard. These
cover the huge bulk of users but I was basically looking for suggestions about
anything else that I should be looking for, particularly from people who have
been upgraded where I missed something.

Cheers,

Andrew

Dan Langille wrote:

> On 25 Nov 2000, at 11:29, Andrew Cutler wrote:
>
> > If anyone has any questions or comments about what the scripts can pick up
> > in your old config and put on your new modem pelase post them here as it
> > would help us to automatically configure more users.
>
> What types of things in the config should we be thinking about? For
> example..
> --
> Dan Langille
> The FreeBSD Diary - http://www.freebsddiary.org/
> NZ Broadband mailing list - http://www.unixathome.org/broadband/
>
> This message is part of the NZ ADSL mailing list.
> see http://unixathome.org/adsl/ for archives, FAQ,
> and various documents.
> To unsubscribe: send mail to majordomo@unixathome.org
> with "unsubscribe adsl" in the body of the message

--
I found a programme to do the entire Y-2-K conversion process on my PC!
I don't understand it but I will be finished sometime todak.
This message is part of the NZ ADSL mailing list.
see http://unixathome.org/adsl/ for archives, FAQ,
and various documents.
To unsubscribe: send mail to majordomo@unixathome.org
with "unsubscribe adsl" in the body of the message