Ping is blocked by default in new M1122 firmware, from memory.
Your pinholes should work correctly, I think I pinholed both tcp and udp on
that port to be certain..

At 02:08 4/10/01 +0000, petert@cohesive.co.nz wrote:
>Help ! (please)
>
>I have just purchased 2 new Nokia M1122's
>
>- on one of them I have asked for a static IP address from Paradise (our
>ISP) -
>have checked that the modem has picked it up (shows that yes it has)
>
> From the outside world you cannot ping the address (I tried both from
> home, and
>rang the ISP while I was onsite to were I could confirm that the VCC1
>interface
>showed the correct address.
>
>Had a look at an older M1122 I look after, and "copied" all the setting that
>apeared relevent over.
>
>I am trying to use MS Terminal Service - opening a pin hole on port 3389.
>
>The only major difference between the new Modems & the old is under the
>config
>page on the new one's there is a "firewall" page - does anyone know about
>this,
>could this be relevent ?. When I am on site next I will do a couple of
>captures
>from the stats page & post here if I am still stuck.
>
> - tried looking at the nokia site & the user manual posted as a pdf here
> for
>more info but could not find anything - any other good sources of info avail ?
>
>
>Thanks in advance
>
>Peter
>
>
>This message is part of the NZ ADSL mailing list.
>see http://unixathome.org/adsl/ for archives, FAQ,
>and various documents.
>To unsubscribe: send mail to majordomo@lists.unixathome.org
>with "unsubscribe adsl" in the body of the message

This message is part of the NZ ADSL mailing list.
see http://unixathome.org/adsl/ for archives, FAQ,
and various documents.
To unsubscribe: send mail to majordomo@lists.unixathome.org
with "unsubscribe adsl" in the body of the message
Received on Thu Oct 4 14:36:55 2001