At 09:44 PM 2/01/02 +1300, Paul wrote:
>Hi Craig
>
>Using the CLI interface, goto #config/password/
>then enter - "user password"
>this will allow you to have a user level password for web and telnet/CLI
>configuration. Like the Admin one you have, this still doesnt seem to need a
>username entered.

This was for an older firmware so it may not still apply, but I'm almost
certain that the Telecom rented M1122's used napt-password not
user-password for the "Telecom" password. Presumably this gave the same
access rights as user-password but allowed you to manage pinholes as well.
I'm not 100% sure, it's a while since I saw one...

Just add a password for napt-user and try logging on with it. (I also
noticed that changing the password applied immediately for telnet, but
needed a reboot for the web interface)

Regards,
Simon

-- 
This message is part of the NZ ADSL mailing list. 
see http://unixathome.org/adsl/ for archives, FAQ, 
and various documents. 
To unsubscribe: send mail to majordomo@lists.unixathome.org 
with "unsubscribe adsl" in the body of the message