are you attempting to connect from outside?
remember NAT?
you should probably use another port on your external side just for
security's sake anyway

-----Original Message-----
From: lurch [mailto:lurchnz@xtra.co.nz]
Sent: Wednesday, 5 June 2002 6:06 a.m.
To: adsl@lists.unixathome.org
Subject: M1122 and Telnet

Hi,
 
Currently I am trying to run a Telnet BBS, but so far without any luck.
The problem comes down to the M1122. Whenever I telnet through the
router grabs it and does not forward it through to the BBS software.
 
I have tried running the BBS on another telnet port but nothing gets
through. I have tried setting up a pinhole
On both the 23 port and also the new telnet port that I setup. But still
no luck.
 
Is there anyway to get the M1122 to forward telnet requests on to the
internal ip address instead of stopping it At the router? Or away to
change the TCP port that the M1122 is looking for when you telnet in?
 
I am open to any suggestions, as I have been thrashing this out for the
past week, and haved looked all over Creation to try and find any info
or help about this.
 
Regards.
-=[Lurch]=-

-- 
This message is part of the NZ ADSL mailing list. 
see http://unixathome.org/adsl/ for archives, FAQ, 
and various documents. 
To unsubscribe: send mail to majordomo@lists.unixathome.org 
with "unsubscribe adsl" in the body of the message 
 
######################################################################
Attention: 
This e-mail is privileged and confidential. If you are not the 
intended recipient please delete the message and notify the sender. 
Any views or opinions presented are solely those of the author.
######################################################################
-- 
This message is part of the NZ ADSL mailing list. 
see http://unixathome.org/adsl/ for archives, FAQ, 
and various documents. 
To unsubscribe: send mail to majordomo@lists.unixathome.org 
with "unsubscribe adsl" in the body of the message