Hi Tony
Just tried that and still no go.
In The Rave2 Docs it says..
FPI ...(Firewall / Proxy server / Internet connection sharing service)
The FPI must re-send these packets to the remote Rave 2 WITHOUT changing
port numbers.
...............
Current Startup config.
ip service AllUDP udp 1000 65000
 ip filter AllUDP all all pass
 ip napt-server AllUDP 192.168.0.2
 dhcp mode server
 dhcp save-interval 10

Any Other Things I could try ??
===================================
From: "Tony Dale" <Tony.Dale@telecom.co.nz>
Subject: RE: M1122 UDP port Problem With Rave2

To check the port issues, you may want to temporarily open all the ports
near enough and see what happens. if nogo, it is another issue than ports. I
use TCP and UDP starting at port 1000 and forwarding 65000 ports.
===================================
-----Original Message-----

Hi Folks
I've been going Nuts trying to get Rave2 (a small Iphone App) running behind
the M1122.
I thought It was Just a case of opening up 2 UDP ports 2078,2079 and away
it would go.
This was the case when I had another computor with an Internal adsl modem
using Winroute for NAT .
The Configuration of the w2k Box on my Lan running Rave Hasn't changed.
Nokia release .. Gx1x2230.R04

As it Stands, The Nokia Rave setup is ...
Names : "RaveUDP" 2078 2079 UDP

NAPT : "RaveUDP" 192.168.0.2 blank blank (All Connections (Global))

FireWall : "RaveUDP " 192.168.0.2 blank

I have experimented with Heaps of settings.
This is the Minimum to get communications happening in at Least 1
Direction.

Any Ideas as to where I'm going wrong would be greatly appreciated.

Regards
Barry

-- 
This message is part of the NZ ADSL mailing list. 
see http://unixathome.org/adsl/ for archives, FAQ, 
and various documents. 
To unsubscribe: send mail to majordomo@lists.unixathome.org 
with "unsubscribe adsl" in the body of the message