Hi,

Jamie Dobbs wrote:
> I'm trying to get MRTG to graph the ADSL throughput (bps) of a Cisco837
> router. I've searched but haven't been able to find a MIB that work, I
> have tried:
>
> Dialer0:public@<ip>
> ATM0:public@<ip>
> ATM0.1:public@<ip>
>
> but none of these appear to return any data.
> Can anyone offer any assistance?

Sure. This is for a 1721 but the same works on the 837.

1. Set up your SNMP community:

router(config)#snmp-server community snmpaccess RO

2. Plot the throughput of the ATM0 interface:

Target[router_ATM0]: \ATM0:snmpaccess@router:
SetEnv[router_ATM0]: MRTG_INT_IP="" MRTG_INT_DESCR="ATM0"
MaxBytes[router_ATM0]: 160000
AbsMax[router_ATM0]: 256000
RouterUptime[router_ATM0]: snmpaccess@router:
Title[router_ATM0]: Traffic Analysis for ATM0 to Orcon -- router

3. I also plot the DSL linespeed:

Target[router_ADSL_LINESPEED]:
transmission.94.1.1.4.1.2.8&transmission.94.1.1.5.1.2.8:snmpaccess@router

If you are doing your measurements from inside and behind the router, use the
Ethernet0 interface IP address to poll, not the outside one.

reuben

-- 
This message is part of the NZ ADSL mailing list. 
see http://unixathome.org/adsl/ for archives, FAQ, 
and various documents. 
To unsubscribe: send mail to majordomo@lists.unixathome.org 
with "unsubscribe adsl" in the body of the message